Both an air bag system and a Timbren system are meant to enhance the performance of your existing vehicle suspension. Either system is meant to be used in conjunction with other components of your suspension system, but are not intended to be a stand alone replacement of your existing suspension.
A Timbren system works to replace your existing jounce stop on either the front or rear suspension. Timbren systems work to level the load on your vehicle, increase stability and handling, decrease... view full answer...
Timbren does offer a suspension kit for the rear of your 2001 Ford F-53 Class A Motor Home. It is the Timbren Rear Suspension Enhancement System, part # TFRF53A. It will install in place of the bump stops on the vehicle. They are designed to work with a suspension system that is in good working order. They are not designed to be used as the main suspension system on your vehicle.
It works by being installed on the vehicles frame rail one inch above the rear axle. The one inch clearance... view full answer...
I do have an airbag suspension enhancement setup for your 1987 Toyota Land Cruiser's rear axle but I would strongly recommend replacing both front and rear leaf springs first. The leaf springs are a critical part of your vehicle's suspension and without them working properly you run the risk of further damage to other suspension components. Our suspension enhancement kits are designed to aid the factory suspension not substitute or replace components.
The only airbag kit we have for your... view full answer...
We do carry a variety of suspension enhancements such as air bags for your 2001 Chevrolet Silverado 2500HD but all of which are designed to reduce vehicle sag and aid the wear life of current suspension components. None of our suspension enhancements are designed to increase the towing capacity of your vehicle. According to Nada Guides, the max towing capacity of your truck is 10,500 lbs. Therefore, I cannot recommend you use this vehicle for towing a 15,500 lb. 5th wheel trailer.
Should... view full answer...
Yes, you will have to install 3 spacers of # A25723-90AH00 on each side if you plan to install the Timbren Front Suspension Enhancement System. Each spacer is 1 inch thick and 3 will compensate for the 3 inch lift you have on your 2009 Chevrolet Silverado 1500 4X4.
For your vehicle, there are two suspension enhancement kits available based on weigh capacity. The Timbren # TUF100 has a capacity of 3,000 lbs and the Timbren # TGMFK15CA has a capacity of 14,000 lbs.
Remember, vehicle suspension... view full answer...
The Timbren Front Suspension Enhancement System, part # TGMFK35C, will fit your 1995 Chevrolet Tahoe 4WD with torsion bar front suspension. The Timbren rubber springs will install in place of your factory bump stop. You will want to make sure that the suspension on your vehicle is in good working order before installing the Timbren kit.
The Timbren kit is designed to work on vehicles with a snow plow. The rubber springs will raise the front of the end of the Tahoe when heavy equipment,... view full answer...
I can help you find the right Super Springs Vehicle Suspension Enhancer for your 2012 Ford F-250. The SSA15 is custom fit for the 2008-2010 Ford F-250 so it will not fit your 2012.
The correct custom fit Super Springs Vehicle Suspension Enhancer for your 2012 Ford F-250 is the # SSA13.
I have also linked all the other custom fit suspensions for your F-250 for your convenience. view full answer...
The Air Lift Vehicle Suspension, # AL59531, is designed to fit the 2003 Chevy S-10 4x4 as long as it does not have a track bar. A track bar is a part of vehicle suspension on some vehicles that is designed to provide lateral location of the axle.
We do have a suspension enhancement system designed specifically for a ZR2 model. Take a look at the Timbren system, # TGMRS10A. I have included a link to the installation details for you to view. view full answer...
Suspension enhancement kits like the SumoSprings Solo part # SS98DR to provide additional support for the vehicle suspension but the reason that does not increase the overall towing capacity of the vehicle is because there are other factors that need to be considered as well like engine, braking, transmission, chassis, differential, and cooling system capacity. Since the suspension is only one aspect of a vehicle's capacity these kits do not increase capacity for everything. view full answer...
I spoke with my contact at Timbren, and he said that the Timbren suspension can work with the Firestone air springs as long as there is room to mount the rubber springs above the rear axle. The Timbren rubber springs will replace the axle bump stops on the vehicles frame. As long as you still have the bump stops on your 2001 Chevrolet Silverado 1500, you will be able to use the Timbren Vehicle Suspension, part # TGMRCK25S. If the bump stops have been removed then the Timbren suspension... view full answer...
Timbren rear-axle suspension kit # TFREXPA is a confirmed fit on the 1999 Ford Expedition, both the 2WD and 4WD versions, and it is indeed compatible with the OEM air suspension package in your Eddie Bauer edition. The installation instructions, which I have linked for you, indicate that the Timbren spring replaces your factory bump stop on each end of the rear axle. This is positioned to the outside of the rear coil spring on both sides of the vehicle as shown in the diagram that is included... view full answer...
I believe you are referencing the Timbren suspension enhancement and there are spacers available, the Timbren 1" Spacer For Raised Frame Vehicles # A25723-90AH00.
The correct Timbrens for your 2018 Ram 1500 will depend on what cab you have:
- Regular Cab: Timbren Rear Suspension Enhancement System # TDR1500DS
- All Other Cabs: Timbren Rear Suspension Enhancement System # TDR1500DQ view full answer...
The Air Lift SmartAir II Automatic-Leveling Compressor System for Air Helper Springs - Dual Sensor # AL25491 is not vehicle specific, so it can be used on your vehicle. The Kelderman suspension has not been tested with this compressor so I can't confirm the fit. If the pressure and fittings align it doesn't give any reasoning why it wouldn't, but this has only been tested and confirmed to work with aftermarket air bags that are supplemental to the factory suspension. view full answer...
The Firestone Ride-Rite Air Helper Springs, part # F2286, on the rear of your 2007 Dodge Ram 1500 is designed to absorb road shock when your truck is loaded. It provides additional support for the existing suspension. It is not designed to smooth out the ride of your factory suspension when there is no load on the vehicle suspension. It will increase stability and improve ride quality when you are hauling a heavy load.
The suspension enhancements that I have are designed to provide additional... view full answer...
The Timbren Vehicle Suspension, part # TGMFK15CA is designed to fit the front of your 2012 Chevrolet Silverado 1500.
This system does not affect the ride when your Silverado is not carrying a load. This replaces the bump stops on your truck and there is no drilling required for installation. The rubber springs work independently side-to-side and help compensate for off-center loads. They also help take away a lot of the bumps on rough roads and extend the life of your vehicle suspension.... view full answer...
We have air bag style suspension enhancement that fits your 2019 Ram 5500 with the part # F2404 which will work really well to provide additional support to the factory suspension as needed since you can adjust the air pressure in the bags to increase or decrease support. That said, we don't offer an air suspension system replacement to convert the vehicles to air ride if that's what you were referencing.
Then for the 2019 3500 Ram we have the Air Lift kit part # AL88231 as a confirmed... view full answer...
The Timbren Rear Suspension Enhancement System, part # TTORTUN4, will install in place of the bump stop on your 2009 Toyota Tundra 4wd. If your bump stop is still on your vehicle the Timbren system will fit. The Timbren system will need to have a clearance of one inch between the frame and the top of the rubber spring. This allows the factory suspension to work normally under light loads and standard terrain.
When your vehicle is loaded or goes off-road the rubber springs will compress... view full answer...
The Firestone Coil-Rite Air Helper Springs, part # F4124, would be the correct part number for the rear of your 1996 Toyota Land Cruiser if it is a four wheel drive model. They do not offer any system for the front of your vehicle. I would not recommend to try to use the rear springs on the front of your vehicle. I am including a link to the installation instructions on the Firestone rear springs.
Firestone does offer lift spacers for vehicles that are lifted but they will not work with... view full answer...
I reached out to my contact at Timbren who said while they haven't fit the Timbren Suspension Enhancement System # TGMFK15CB on a 2016 GMC Sierra 1500 with the MagneRide suspension, they have yet to see this kit not fit the front suspension of a vehicle with the MagneRide on it. So even though they haven't test fit it themselves they verified that it will work.
To ensure that it will fit with your 2-1/2" level you just need to make sure that there is about 6-1/2" - 8" between the mounting... view full answer...
The Timbren suspension enhancement will replace the axle bump stops on your 2007 Toyota FJ Cruiser. They will work independently front and rear, and side to side. So, when you are carrying a heavier load on the passenger side of the vehicle it will compress the hollow rubber spring and become more rigid as the load is applied. This will help keep the vehicle from leaning heavily to that side. It will not affect the empty ride of your FJ Cruiser.
The Timbren suspension has a weight capacity... view full answer...
Go To Results